KUHN GMD 55, Руководство по сборке и эксплуатации

Страница: 31 / 44

- 29 -
BELTS
The belts must be properly tensioned at all times to
prevent excessive slipping and flopping. Loose belts
will also cause poor cutting and premature failures.
To tension the belts, loosen the 2 nuts (A) and tighten
nut (B) (photo 46) (see § 2, page 12).
Belt tension is correct if deflection does not exceed
10 mm (2/5") when belts are pressed upon with
a force of 3,5 daN (8 lbs).
Belt tension must regularly be checked, especially
during the first few hours of use. Only replace belts as
a complete set.
1. KEEP ALL SHIELDS IN PLACE AND REPLACE IMMEDIATELY USING GENUINE KUHN SPARE PARTS
IF WORN OR DAMAGED.
2. TO CARRY OUT SUCH OPERATIONS AS LUBRICATION, CLEANING, UNBLOCKING OR ANY
ADJUSTMENTS, STOP THE TRACTOR ENGINE, REMOVE IGNITION KEY AND DISCONNECT THE
PTO SHAFT, UNLESS OTHERWISE STATED IN THIS OPERATION MANUAL.
3. WAIT FOR ALL MOVEMENT TO STOP BEFORE SERVICING THE MACHINE.
4. KEEP HANDS, FEET AND CLOTHING AWAY FROM POWER DRIVEN PARTS.
5. KEEP OFF EQUIPMENT UNLESS SEAT FOR OPERATION IS PROVIDED.
6. BEFORE STARTING UP THE MACHINE AND BEGINNING WORK, KEEP ALL PERSONS AND ANIMALS
AWAY FROM THE DANGER ZONE OF THE MACHINE (RISK OF PROJECTION !).
CROP DIVIDER
Tighten the compressing spring (L) (photo 47) so the
divider can move freely if an obstruction is hit.
CAUTION : REGULARLY CHECK ALL
NUTS AND BOLTS FOR TIGHTNESS
PARTICULARLY THOSE SECURING
THE DISCS AND BLADES.