KUHN GA 6000, Руководство по сборке и эксплуатации

Страница: 14 / 40

- 12 -
2. ASSEMBLING THE TWO MACHINE HALVES (photos 1 and 2)
- Assemble the 2 front (1) and rear (2) parts using 2 pins (A), 2 roll pins (G) (diameter 8 x 65) and 2 roll pins (H)
(diameter 5 x 55) (photo 1).
- Position rear lights wiring harness and the hydraulic hoses (R) on top of rear beam (T) and mount hose
cover (C) (photos 1 and 2).
- Mount double acting cylinder (V) using axle (O) and 2 roll pins (P) (diameter 8x30) on cylinder barrel side (photo
1A) and using axle (Q) and 2 roll pins (D) (diameter 4x30) on cylinder rod side (photo 2).
- Connect hydraulic hose (L) to rear rotor lock (H) (photo 2).
- Pass hydraulic hose (B) through the rear rotor axle (photo 2) and connect it to rear undercarriage cylinder (D)
(see photo B, page 11).
3. FITTING THE FRONT SAFETY GUARDS (photos 3 and 4)
- Fit the front guards (E), with their curved ends facing downwards, on each side of the front frame
(I)
with 4
hexagonal screws (J) (M 12 x 35), 4 lock washers (M 12), 4 hexagonal nuts (M 12), 4 hexagonal screws (K) (M
8 x 40), 4 plain washers (diameter 9 x18 x 1.5) and 4 self locking nuts (M 8) (photo 3).
- Fit the hose support (S) to the front right guard using a U-bolt (M) and 2 self locking nuts (N) (M 8) (photo 4).
- Connect the hydraulic hoses and the wiring harness cable to the support (S) using the plastic clamp collars (D)
(length 176 mm) (photo 4).
4. MOUNTING OF THE REAR CONSOLE (photo 5)
Mount the rear console (W) on the casting (X) by means of 4 self-locking screws (Y) (M 16 x 25) (torque 21 daNm/
155 ft.lbs) after checking that the electric cables (Z) for the rear signalling have been pulled through.