KUHN GA 4511 GM, Руководство по сборке и эксплуатации

Страница: 12 / 40

- 10 -
ASSEMBLY INSTRUCTIONS
To reduce bulk when shipping the GA 4511 GM , some parts have not been fitted to the machine.
Before starting to assemble, make sure the bogie axle caster wheels are in the right position (see front page photo).
1° Fitting the guard’s rear support and front hinges
- Fit the guard’s rear support (A) on beam (B) with 6 hexagonal screws (C) (M 12 x 40) and 6 self-locking nuts (M
12). Torque to 8.5 daNm (60 ft.lbs) (photo 2).
- Fit front hinges (F) on beam (B) with 8 screws (G) (M 10 x 35) and 8 self-locking nuts (M 10) ; do not tighten (photo
3).
2° Fitting the guards
- At the front of the machine fit the left guard (H) and right guard (J) on front hinges (F) using 2 roll pins (I) (8 x
45) (photo 6).
- Fit guards (J) and (H) on rear support (A) using roll pins (K) (8 x 55) with spacer (L) (40 x 51 x 7.5) on the right
side (photo 4) and the stop plate (M) on the left side (photo 5) as seen in the direction of travel.
- Now tighten screws (G) to a torque of 5 daNm (37 ft.lbs) (photos 3 and 6).
3° Fitting the hydraulic cylinder and hoses