KUHN FC703, Руководство оператора

Страница: 35 / 100

Putting into service
Mower conditioner
FC703 RA*
33
„
Primary PTO shaft
The tractor PTO stub must rotate at a speed of 1000 min
-1
.
Separate the two half PTO shafts and connect them to
the machine's input shaft and to the tractor PTO stub.
Check the length of the PTO shaft:
- When the PTO shaft is in its maximum overlap
position (retracted), tubes should not butt against the
yokes. As a safety measure, a clearance (L) of at least
25 mm (1’’) must be maintained.
- When the PTO shaft is in its maximum extended
position, the tube overlap must be more than
250 mm (10’’).
Never operate the PTO shaft at an angle X exceeding
30°.
Make sure that the PTO shaft is correctly
adjusted, to avoid premature wear and tear.
To avoid serious accidents, the PTO drive
shaft guards must be properly in place and
fixed with the chains provided.
Immediately replace any worn or damaged
guard.