Kubota F5205, Инструкция по установке и эксплуатации, Страница: 7 / 21

8. COWL
8.1 With assistance, install the cowl to the lower front
of the side frames. Use two 5/16” x 3/4” long button
head bolts, two steel washers, and two plastic washers
per side to connect to the factory installed threaded
inserts in the side frame tubing. See fig. 8.1. Install one
5/16” x 3/4” long button head bolt, two steel washers,
and one locknut through the floorboard with the head
of the bolt up top as shown in fig. 8.1.1. Repeat for
opposite side. Leave bolts loose.
Fig. 8.1 (view from front of right side)
button head bolts,
plastic washers,
and steel washers
Fig. 8.1.1 (view from front of right side)
bolt through cowl
(bolt head up top)
PAGE 7 OF 21
9. WINDSHIELD SUPPORT
9.1 With assistance, install the windshield support to
the upper front of the side frames. Use one 5/16” x
3/4” long button head bolt, one steel washer, and one
plastic washer in the lower hole on each side of the
windshield support (into the factory installed threaded
insert in the side frame tubing). See fig. 9.1. Install two
5/16” x 3/4” long button head bolts, four steel washers,
two plastic washers, and two locknuts to the middle
and upper holes in the windshield support. Locknuts to
be towards the inside of the cab. Repeat for opposite
side. Leave bolts loose.
10. WORK LIGHTS
10.1 Install the two supplied grommets in the lower of
the two holes in the front face of the windshield sup-
port. Install the work light bolts into the upper of the 2
holes in the windshield top. Run the wires through the
holes with grommets below as shown in Figure 10.1.
(Note: The work lights are mounted upside down)
plastic washer
Fig. 9.1 (view from front of right side)
Fig. 10.1 (view from front of right side)