Kubota F5205, Инструкция по установке и эксплуатации, Страница: 11 / 21

18. WINDSHIELD WIPER
CAUTION: Make sure that the metal parts of the wiper motor do not contact the glass during installation. Damage
could occur. WARNING: Over tightening wiper mounting hardware can damage windshield and components.
18.1
Install the pantograph wiper motor as shown below in figure 18.1. Install blade to arm and arm to wiper motor.
A factory installed set screw has been provided to ensure that the arm does not work its way off the splined shaft of
the motor. Tighten that one set screw to 2 foot-pounds max. (or 24 inch-pounds max.).
PAGE 11 OF 21
19. FINISHING TOUCHES
19.1 Install nut covers on all exposed nuts inside the cab. Also install on the nut protruding from the roll bar brackets.
19.2 Cut the supplied grit paper to fit on each of the side frame floorboards to prevent slipping when entering or exiting
the cab. Adhere the grit paper to a clean dry surface at room temperature.
20. CARE AND MAINTENANCE
20.1 Check and tighten hardware after 40 hours of operation. Periodically inspect and tighten hardware for the remainder
of the unit’s life.
20.2 Wash the painted surfaces of the unit with commercial automotive cleaning products.
20.3 Clean windows with glass cleaner.
Fig. 18.1 (wiper motor installation)
1/4-20 Cap Nut
Plastic Cup Washer
Large Rubber Washer
Hex Nut
Plastic Cup Washer
Large
Rubber
Washer
10-32 x 3/4”
Bolt
Pantograph
Wiper Mount
Small White
Nylon Bushing
Large White
Nylon Bushing
Medium White
Nylon Bushing
Windshield
Steel Washer
10-32 Locknut
Small Rubber
Washer
Black Plastic
Standoff
1/4-20 x 5/8” Bolt
Internal tooth
lock washer