Kubota F5205, Инструкция по установке и эксплуатации, Страница: 3 / 21

PAGE 3 OF 21
1. DECK SOUND BARRIER
Mounting surface preparation: adhesive-
backed sound barrier should be applied to a
clean, dry surface at room temperature. Alt-
hough the mounting surface may appear
clean, it is required that the surface be clean-
ed with isopropyl alcohol or an acetone or
ammonia-based cleaner immediately prior
to application of the sound barrier material.
Allow cleaned surfaces to dry thoroughly.
Good surface contact is required to achieve
bond. Failure to follow these steps can result
in the separation of the sound barrier mate-
rial from the mounting surfaces.
NOTE: paint thinners or products with any
oil in them will not work and are detrimental
to the proper cleaning of the underside of the
fender. NOTE: clean rags are very im-
portant. Oily rags will leave residue.
1.1 Remove the ROPS (Roll Over Protection Structure)
structure, the operator seat, the control lever handles, the
differential lock, forward - reverse and brake pedals
from the mower. Remove the operator deck by removing
the two bolts at the back of the deck and the four nuts (2
each side) from the frame supports under the left and
right foot wells. Open the hood, lift the deck up off of the
front mounting studs, tip the back of the deck up and
move to the rear lifting off of the park brake lever and
the steering column cover. Reference Kubota mower
service manual for a more detailed description.
1.2 Remove the grab handle from the left side by remov-
ing the two (2) hex nut/washer combinations (SEMS)
from underneath the fender. Discard hardware and han-
dle. See fig. 1.2.
1.3 Position the operator deck upside down on a soft
table to prevent scratching. Remove all 10 plastic pine
tree clips (5/side) that hold the floor mats in place. Dis-
card these 10 small, short plastic clips. 16 larger, longer
plastic pine tree clips are provided in the hardware bag
along with 16 fender washers (1/4” I.D.).
1.4 Note: dry fitting the pieces to get a feel for location
is suggested before peeling back the protective paper.
Place the main piece of sound barrier on a flat table with
the adhesive side up. Cut the center rear section of the
adhesive backing paper 15” from the rear edge as shown
in fig. 1.4.
1.5 Position the main piece of the deck sound barrier in
place as shown in fig. 1.5. Lift up one section at a time,
peel the adhesive backing paper off and adhere the sound
barrier to the deck.
DO NOT remove 15” of backing
paper of rear center section that was cut in step 1.4.
1.6 Position the left and right pieces of sound barrier as
shown in fig. 1.6, peel the adhesive backing paper off
and adhere to the deck as shown.
Fig. 1.2 (grab handle)
Fig. 1.4 (modify sound barrier)
Fig. 1.5 (main sound barrier)
Fig. 1.6 (left and right sound barrier)
rear edge
Left and right sound barrier
Main sound barrier
cut adhesive back paper 15” from
rear edge. (center section only).