Kubota F5205, Инструкция по установке и эксплуатации, Страница: 6 / 21

Fig. 6.1 (view from rear of right side)
button head bolts,
plastic washers,
and steel washers
threaded stud
lower rear panel
Fig. 5.1 (view from rear of right side)
5. LOWER REAR PANEL
5.1 With assistance, install the lower rear panel onto
the threaded shafts of the two rubber bumpers. Use
3/8” locknuts and washers as shown in fig. 5.1. Tighten
both locknuts.
5.2 Do not peel off the backing paper on the sound
barrier material until step 7 (just prior to installing the
upper rear panel assembly).
PAGE 6 OF 21
6. RIGHT SIDE FRAME
6.1 With assistance, remove the doors from both
side frames by opening and lifting up off of the pin
hinges. Next, position the right side frame so that two
of the holes in the floorboard of the side frame line up
with the threaded inserts in the two front rubber bump-
ers. Loosely install two 5/16” x 3/4” long button head
bolts and two steel washers. Do not tighten bolts. At-
tach the rear of the side frame to the lower rear panel
using two 5/16” x 3/4” long button head bolts, two
plastic washers, and two steel washers (see fig. 6.1).
Note: the side frame tubing has factory installed
threaded inserts.
CAUTION: to avoid cross thread-
ing the factory installed threaded inserts, start the
bolts by hand (no tools).
Do not tighten these bolts
yet. The other side frame will be installed in step 7
(after the rear panel is positioned).
7. REAR PANEL & LEFT SIDE FRAME
7.1 NOTE:The rear panel must be positioned in
place at this time because clearances will not allow
it to be put in place after side frame installation.
7.2
At this time, peel back the narrow protective sheet
remaining on the sound barrier of the lower rear panel.
Fold it down on to the 90 degree bend of the lower rear
panel. Note: adhesive-backed sound barrier should be
applied to a clean, dry surface at room temperature.
7.3 With assistance, place the rear panel in position
and rest it against the ROPS (see fig. 7.1).
7.4 With assistance, install the left side frame so that
two of the holes in the floorboard of the side frame line
up with the threaded inserts in the two front rubber
bumpers. Loosely install two 5/16” x 3/4” long button
head bolts and two steel washers. Do not tighten bolts.
7.5 Attach the rear of the side frame to the lower rear
panel using two 5/16” x 3/4” long button head bolts,
two plastic washers, and two steel washers (as shown
in figure 6.1). Do not tighten bolts.
Fig. 7.1 (view from front of left side)