5 Commissioning and Operation
Kübler Group
24 | EN
Operation Manual R60071.0009 - 04
If the supply voltage is reversed, the measuring system does
not function.
4.2.6 Electrical connection
Open the plastic cover on the encoder, if necessary using a
screwdriver. Plug the male connector of the cable in the fe-
male connector of the encoder while the encoder is discon-
nected from the power. Then close the plastic cover again.
The snapping must be indicated by a clearly perceptible or
audible click.
5 Commissioning and Operation
DANGER
Risk of injury due to rotating shafts
Hair and loose clothing can be caught by rotating shafts.
• Prepare all work as follows:
ð
Switch the operating voltage off and stop the drive shaft.
ð
Cover the drive shaft if the operating voltage cannot be
switched off.
5.1 Connecting the Connecting Wires
ATTENTION
Destruction of the electronics
When confectioning the sensor cable, always take care to en-
sure sufficient ESD protection.
• Before connecting the connecting wires, check the assign-
ment of the single wires.
• After connecting, check the proper presence of the supply
voltage and the proper functioning.
If the supply voltage is reversed, the measuring system does
not function.
5.2 Operational Readiness when Switching On
The sine and cosine signals are immediately available after
switching on the voltage supply.
6 Maintenance
In harsh environments, we recommend regular inspections
for firm seating and possible damages at the device. Repair
or maintenance work requiring opening the device may only
be performed by the manufacturer.
In the event of questions or spare parts orders, please
provide us the data printed on the type plate of the device.
See chapter Contact [
Prior to the work
• Switch off the power supply and secure it against switching
on again.
• Then disconnect the power supply lines physically.
• Remove operating and auxiliary materials and remaining
processing materials from the measuring system.