4 Installation
Kübler Group
18 | EN
Operation Manual R60071.0009 - 04
4.1.1 General Information for the Installation
ATTENTION
Do not disassemble or open the device
The function of the measuring system might be lost partly or
entirely.
• Do not open or disassemble the measuring system. Other-
wise, the warranty will be void.
NOTICE
Tools
For assembly, use only checked and calibrated tools subjec-
ted to a quality system.
Screws and screwed connections
Unless otherwise specified, a friction coefficient of 0.14 is re-
quired for all screwed connections. Unless otherwise spe-
cified, a strength class of 8.8 (metric) or grade 5 (imperial) is
required for all screws.
4.1.1.1 Assembly Instructions for Tapered Shaft
Encoders
a) Block the drive shaft for the assembly.
b) Tighten the central screw of the tapered shaft.
c) Comply with the maximum permissible shaft offset.
d) Screw the stator coupling or the torque stop without pre-
load on the drive flange.
4.1.2 Montage
NOTICE
Dimensions
The technical drawing with complete dimensioning can be
found in the data sheets of the corresponding variant of the
device, for special versions in the.corresponding quotation /
customer drawing of the product.
The illustrations below only show a selection of examples. All
values without unit in the picture are given in mm [inch].
In order to simplify the drawings and information, unless oth-
erwise specified, the general tolerances with tolerance class
m
(medium) according to ISO 2768-1 apply.
The required assembly steps of the encoder refer to the
graphics at the beginning of this operation manual Product
Overview.
The following partial steps will lead to successful installation
of the encoder: