KTR-STOP
®
S-xx-F B-xx
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
44590 EN
11 of 26
3
Please observe protection
note ISO 16016.
Drawn:
2018-09-10 Shg/Wie
Replacing:
KTR-N dated 2018-02-07
Verified:
2018-09-10 Shg
Replaced by:
KTR supplies brake pads free from asbestos and lead only.
If requested, we will provide you with the corresponding certificates.
The brake pads are each adapted to the application and delivered accordingly.
They can be distinguished as follows:
organic material
powder metal
!
Brake pads are highly sensitive to grease and oil which means that they cannot be cleaned.
Brake pads having such kind of dirt need to be replaced and disposed of.
We would recommend to store the brake pads in their package as long as possible to pro-
tect them from any kind of dirt.
!
Brake pads which have worn off to the wear limit have to be replaced immediately. Make
sure to replace by original parts only.
STOP
In order to avoid any injuries please always make use of proper lifting equipment.
M10 threads are installed in the pad retainer to fasten an eye bolt serving to use lifting tools. The eye bolt is to be
dismounted after assembly of the brake and stored in a safe place.
!
In order to avoid any damages on the brake, never twist a rope or another lifting tool around
damageable components.
Before you start with the assembly please check if a sensor has been mounted.
Please remove it before assembly in order to avoid any damages.
Inspect the position of the setting nut (component 1.7). If necessary, set it to the right dimension (see illustrati-
on 19).
Insert the brake pads (component 7) fully into the brake caliper.
If you want to use brake pads after having assembled the brake, it is necessary to disas-
semble the pad holder (component 1.14 and 1.15) for that purpose (chapter 5.1).
Mount the pad retraction set on the movable side (component 8) by shifting the pressure spring (component
8.2) onto the pin (component 8.1). Screw the pin with the pressure spring into the brake pad against a stop.
Repeat this process with the pad retraction set on the moveable side of caliper (component 6).
Secure the screw connection (component 6.1 and 8.1) on the brake pad additionally against
working loose, e. g. conglutinating with Loctite (average strength).
4
Assembly
4.3 Brake pads
4.4 Assembly of the brake
