KTM F7303R2, Инструкции по установке

Страница: 28 / 45

3 WORK
26
3.10 Installing the front wheel
Warning
Danger of accidents Oil or grease on the brake discs reduces the braking effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when necessary.
H00935-10
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change front wheel bearing.
–
Clean and grease shaft seal rings 1 and contact surface A
of the spacers.
Long-life grease ( p. 41)
–
Insert the spacers.
–
Clean and grease the wheel spindle.
Long-life grease ( p. 41)
–
Lift the front wheel into the fork, position it, and insert the
wheel spindle.
The brake linings are correctly positioned.
V00364-11
–
Mount and tighten screw 2 .
Guideline
Screw, front wheel
spindle M20x1.5 35 Nm (25.8 lbf ft)
–
Operate the hand brake lever several times until the brake lin-
ings are seated correctly against the brake disc.
–
Remove the motorcycle from the lift stand. ( p. 19)
–
Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
Tighten screws 3 .
Guideline
Screw, fork stub M8 15 Nm (11.1 lbf ft)
3.11 Removing the battery
Warning
Environmental hazard Batteries contain environmentally-hazardous materials.
–
Do not dispose of batteries as household waste.
–
Dispose of batteries at a collection point for used batteries.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.