KTM F7303R2, Инструкции по установке

Страница: 7 / 45

2 SETUP
5
–
Route the clutch line with the clutch master cylinder
toward the front between the upper and lower triple
clamps.
–
Install the fork legs. ( p. 25)
S01414-10
(All standard EXC/XC-W models)
–
Remove screws 3 and take off handlebar supports.
–
Move the handlebar supports to the desired position and
mount and tighten screws
3
.
Guideline
Screw, handle-
bar support M10 40 Nm (29.5 lbf ft)
Loctite ® 243™
Info
Position the left and right handlebar supports
evenly.
E00483-01
Warning
Danger of accidents A repaired handlebar poses a
safety risk.
If the handlebar is bent or straightened, the mate-
rial becomes fatigued. The handlebar may break
as a result.
–
Change the handlebar if the handlebar is dam-
aged or bent.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamps. Mount and tighten the
screws evenly.
Guideline
Screw, handlebar
clamp M8 20 Nm
(14.8 lbf ft)
Info
The markings on the handlebar should be at the
center of the handlebar clamps.
Keep the gap widths equal when tightening.