6
FORK, TRIPLE CLAMP
28
200671-10
–
Push on the lower sliding bushing
5
.
–
Mount the upper sliding bushing
6
.
Info
Without using a tool, carefully pull the stack apart by hand.
200723-10
–
Heat up the outer tube in area
A
of the lower sliding bushings.
Guideline
50 °C (122 °F)
–
Slide the outer tube onto the inner tube.
–
Hold the lower sliding bushing with the longer side of the special tool.
Assembly tool (T1402S) (
p. 225)
–
Push the sliding bushing all the way into the outer tube.
200724-10
–
Position the support ring.
–
Hold the seal ring with the shorter side of the special tool.
Assembly tool (T1402S) (
p. 225)
–
Push the seal ring and support ring all the way into the outer tube.
200656-11
–
Mount lock ring
2
.
Info
The lock ring must engage audibly.
200655-11
–
Mount dust boot
1
.
200725-10
–
Mount adjusting tube
7
of the rebound damping in the cartridge.
The adjusting tube protrudes 5 mm from the cartridge and can be pressed in
against the resistance of the spring.
The adjusting tube protrudes more than 7 mm from the cartridge and cannot
be pressed in against the resistance of the spring.
–
Screw on fluid barrier
B
as far as it will go.
Info
The fluid barrier must be tightened as much as possible. Do not use tools.
–
Install the special tool on the cartridge.
Gripping tool (T14026S1) (
p. 225)
Содержание 690 Enduro R 2013
