KTM 690 Enduro R 2013, Руководство по ремонту

Страница: 126 / 234

17 ENGINE
124
Info
When pressing the bearing in, ensure that the engine case section is level to
prevent damage.
Only press the bearings in via the outer bearing race; otherwise, the bear-
ings will be damaged when they are pressed in.
–
After the engine case section has cooled, check that the bearings are firmly seated.
Info
If the bearings are not firmly seated after cooling, it is likely that they will
rotate in the engine case when warm. In this case, the engine case must be
renewed.
–
Mount and tighten screw
A
with the washer.
Guideline
Locking screw for bearing M5 6 Nm
(4.4 lbf ft) Loctite ® 243™
–
Press in the shaft seal ring of countershaft
2
and shift shaft
3
with the open side
facing inwards so that it is flush.
–
Mount and tighten the oil jet
1
.
Guideline
Oil jet, piston cooling M6x0.75 4 Nm
(3 lbf ft) Loctite ® 243™
–
Mount the dowels.
–
Blow compressed air through all oil channels and check that they are clear.
200155-10
–
Measure the spring length of the oil pressure regulator valve.
Oil pressure regulator valve - minimum
spring length 25.36 mm (0.9984 in)
» If the measured value does not equal the specified value:
–
Change the spring.
–
Check the piston valve for damage and wear.
» If there is damage or wear:
–
Replace the piston valve.
300093-10
–
Lubricate piston valve
9
and mount it with pressure spring
8
. Mount and tighten
screw plug
7
with the new seal ring.
Guideline
Oil pressure regulator valve plug M12x1.5 20 Nm
(14.8 lbf ft)
–
Position the membrane support plate
5
with membrane
6
. Mount and tighten the
screws.
Guideline
Screw, membrane fixation M3 2 Nm
(1.5 lbf ft) Loctite ® 243™
Info
The membrane support plate is curved and must point away from the mem-
brane.
An incorrectly installed membrane support plate results in loss of perfor-
mance and increased oil consumption or leaks.
Do not apply thread locker between the membrane and the membrane sup-
port plate since this would impair their function.