KTM 660 SMC SUPERMOTO 2003, Дополнение к руководству пользователя

Страница: 22 / 32

ENGLISH
22
Adjusting screws
The two adjusting screws 1 on the left and right side of the bike are used
to adjust the tail and may not be turned.
WARNING
B
OTH ADJUSTING SCREWS MUST BE CHECKED FOR DISTORTION AND CRACKS AFTER A
FALL
.
Adjusting of basic position at the hand brake lever
The basic position of the hand brake lever may be readjusted by using
adjustment screw
2
. In this way, the position of the point of pressure (i.e.,
the resistance you feel on the hand brake lever when the brake pads are
pressed against the brake disc) can be adjusted for any hand size.
Checking of brake fluid level - front brake
The brake fluid reservoir is mounted on the handlebars. The brake fluid
level should not drop below the MIN mark in a horizontal position. If
necessary, add DOT 5.1 brake fluid (e.g. Motorex Brake Fluid 5.1).
WARNING
– I
F THE BRAKE FLUID LEVEL DROPS BELOW THE MINIMUM EITHER THE BRAKE SYSTEM
HAS A LEAK OR THE BRAKE PADS ARE COMPLETELY WORN
. I
N THIS CASE
,
CONSULT AN
AUTHORIZED
KTM
DEALER IMMEDIATELY
.
– T
HE BRAKE FLUID RESERVOIR MUST BE MOUNTED IN A HORIZONTAL POSITION
,
OTHERWISE AIR CAN GET INTO THE BRAKE SYSTEM
.
Checking the rear brake fluid level
The reservoir for the rear disk brake is located in the air filter box under the
seat.The brake fluid level must not drop below the ”MlN” marking when
the vehicle is in an upright position.
WARNING
I
F THE BRAKE FLUID LEVEL DROPS BELOW THE MINIMUM EITHER THE BRAKE SYSTEM HAS A
LEAK OR THE BRAKE PADS ARE COMPLETELY WORN
. I
N THIS CASE
,
CONSULT AN AUTHO
-
RIZED
KTM
DEALER IMMEDIATELY
.
2
1
1