ENGLISH
22
1
2
4
3
A
1
2
5
6
7
8
9
10
Replace the oil filter when changing the engine oil. Press the foot brake
pedal and place a screwdriver or similar between foot brake pedal and
stopper roll so that the oil filter cover is more accessible. Remove banjo bolt
1
and the three screws. Remove oil filter cover
2
and oil filter. Clean the
filter case, oil filter cover and sealing areas. Make sure the oil duct in the oil
filter cover is not clogged.
Place the new oil filter
3
on the connection in the oil filter cover and mount
together with a new seal
4
. Tighten the 3 screws in the filter cover to
5 Nm. Tighten the hollow screw with seals and tighten to 15 Nm.
Clean the plugs thoroughly with petroleum and compressed air in order to
remove any metal filings. After the oil has drained completely, clean the
sealing areas and remount the plugs together with their gaskets. Tighten
plug
5
with 30 Nm and plugs
6
and
7
with 20 Nm. Tighten the screw
8
with 10 Nm. Clean sealing surfaces on the frame breast pipe
9
, fill new fine
screen filter with engine oil, and oil rubber gasket
bk
. Replace fine screen
filter and screw it back in place, your bare hand will do.
Remove oil dipstick on the clutch cover, fill with 1.3 litre (0.34 US gallons)
engine oil and attach plug again.
!
CAUTION
!
– U
SE ONLY ORIGINAL
KTM
OIL FILTER
,
FINE FILTER AND MICROFILTER
. U
SING ANO
-
THER FILTER BRAND CAN RESULT IN DAMAGE TO THE ENGINE
.
–
I
F THE ENGINE OIL HAS BEEN DRAINED FROM THE FRONT PIPE OF THE FRAME
,
YOU
MUST BLEED THE OIL SYSTEM
!
To facilitate bleeding of the oil system, we have added a hose connection
piece and a plastic hose to the set of tools. Take an empty oil can (1 liter)
and drill a 7 mm (0.28 in) -diameter hole into the lid. Screw the hose
connection piece into the lid from the outside, and secure it from the inside
with the M8 hexagon nut.
Slip the plastic hose onto the hose connection piece, and you will have your
filling tool.