KTM 2015 450 Rally Factory Replica, Руководство пользователя

Страница: 98 / 133

19 CLEANING, CARE
96
19.1 Cleaning the motorcycle
Note
Material damage Damage and destruction of components by high-pressure cleaning equipment.
–
When cleaning the vehicle with a pressure cleaner, do not point the water jet directly onto electrical components, connectors,
cables, bearings, etc. Maintain a minimum distance of 60 cm between the nozzle of the pressure cleaner and the component.
Excessive pressure can cause malfunctions or destroy these parts.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
To maintain the value and appearance of the motorcycle over a long period, clean it regularly.
Avoid direct sunshine when cleaning the motorcycle.
401061-01
–
Close off the exhaust system to keep water from entering.
–
Remove loose dirt first with a soft jet of water.
–
Spray very dirty parts with a normal commercial engine cleaner and then brush off
with a soft brush.
Motorcycle cleaner ( p. 125)
Info
Use warm water containing normal motorcycle cleaner and a soft sponge.
Never apply motorcycle cleaner to a dry vehicle; always rinse the vehicle
with water first.
–
After rinsing the motorcycle with a gentle spray of water, allow it to dry thoroughly.
–
Remove the closure of the exhaust system.
Warning
Danger of accidents Reduced braking efficiency due to a wet or dirty brake
system.
–
Clean or dry a dirty or wet brake system by riding and braking gently.
–
After cleaning, ride the vehicle a short distance until the engine warms up.
Info
The heat produced causes water at inaccessible locations in the engine and
on the brake system to evaporate.
–
Push back the protection caps of the handlebar controls to allow any water that has
penetrated to evaporate.
–
After the motorcycle has cooled off, lubricate all moving parts and bearings.
–
Clean the chain. ( p. 60)
–
Treat bare metal (except for brake discs and the exhaust system) with a corrosion
inhibitor.
Preserving materials for paints, metal and rubber ( p. 125)
–
Treat all plastic parts and powder-coated parts with a mild cleaning and care prod-
uct.
Special cleaner for glossy and matte paint finishes, metal and plastic surfaces
( p. 125)
–
Oil the steering lock.
Universal oil spray ( p. 126)