31
4.4.11 Device address setting
Device address setting(Note: the information in the red box will be flashing)
Press “ON” under the battery temperature compensation sensor switch setting or press “OFF”
under parallel ID set- ting, goes to the device address setting. The setting state flashes as above
picture shows (Note: device address is1~15, it is the MODBUS device address at RS232 &
RS485 communication ports.
①
Press “
” to set the address, with options 1~15. When battery
temperature sensor is open, can choose 1~10 & 13~15; If it’s parallel mode and device address
<= parallel quantity, device address= parallel ID.
②
Press “ON” to exit the device address setting
and save the device address setting value and parallel ID setting. (Note: Under single UPS mode,
until this device address setting save and exit, single UPS setting is done.)
③
Press “OFF” to exit
the device address setting and transfer to battery temperature compensation sensor setting.
4.4.12 Parallel ID setting
Parallel ID setting (Note: Inside the broken-line is the flashing part.)
When in device address setting press “ON” or when under parallel quantity setting press “OFF”,
it goes to the parallel ID setting. The parallel ID flashes as in above picture.
①
Use button “
” to set
the different parallel ID. The parallel ID range is 1~4.
②
press “ON” to exit the parallel ID setting and
save the parallel ID setting value and goes to parallel quantity setting.
③
press “OFF” to exit the
parallel ID setting and goes to device address setting.
CAUTION!
Parallel cable cannot be connected when setting the parallel
parameters.
