KSM-Stoker KSM-Multistoker 175-13, Инструкция по эксплуатации, Страница: 20 / 69

- 17 -
6.19 Fan step 0.
The fan speed decides the output, and in step 0 you want a very small output as this is just before the
plant switches into the pause mode. The speed is adjusted by the fan receiving pulsating signals, these
can be clearly heard in the low steps.
FAN STEP 0
Press ”MENU”
FAN STEP 0
FAN STEP 1 ADJUST 005
Use the arrow keys to select the fan speed, you may choose between values from 001 to 080.
After selection of the wanted fan speed, press ”MENU”, and your choice has been saved.
Press ”
▼
” to proceed to the next parameter you wish to change – or press the ”START-UP” and the
“MENU” keys at the same time to finish.
6.20 Fan step 1.
As a starting point, the speed in step 1 should be 3 times as high as the speed in step 0.
FAN STEP 1
Press ”MENU”
FAN STEP 2
FAN STEP 2 ADJUST 010
Use the arrow keys to select the fan speed, you may choose between values from 001 to 080.
After selection of the wanted fan speed, press ”MENU”, and your choice has been saved.
Press ”
▼
” to proceed to the next parameter you wish to change – or press the ”START-UP” and the
“MENU” keys at the same time to finish.
6.21 Fan step 2.
As a starting point, the speed in step 2 should equally be 3 times as high as the value of the preceeding
step, i.e. in this case of step 1.
FAN STEP 2
Press ”MENU”
FAN STEP 2
FAN STEP 3 ADJUST 030
Use the arrow keys to select the fan speed, you may choose between values from 001 to 080.
After selection of the wanted fan speed, press ”MENU”, and your choice has been saved.
Press ”
▼
” to proceed to the next parameter you wish to change – or press the ”START-UP” and the
“MENU” keys at the same time to finish.
6.22 Fan step 3.
As a starting point, the speed in step 3 is always set at 80 which is the maximum speed. In case of very
light fuels, it may be necessary to reduce the speed.