KSB GIW MDX, Инструкция по установке и эксплуатации

Страница: 11 / 53

MDX [en-US]
11
3.2.3 Pump Parts Storage
CAUTION
For proper storage ensure:

All machined surfaces must be coated with rust protector

Grease and plug all drilled and threaded holes

Check monthly for paint breakdown on casting

Check monthly for visible sign of rust on machine surface

Check monthly forgeign matter buildup in drilled/threaded holes

Remove rust with wire brush and recoat machined surfaces with a rust inhibitor as needed

Remove rust with wire brush and repaint casting surfaces as needed
All pump parts must be stored indoors. The only exception is for large castings such as pedestals, pump casings,
impellers, etc… See chart below for details.
Pump Part Storage Requirements
Pedestal
Casing
Casing Half
Liner
Plate
Impeller
Sub-base
 Outdoor storage with monthly inspection permitted for these parts only
 Lay sub-bases flat and do not stack
Rubber
Elastomers
Urethane
Neoprene
 Check expiration date (shelf life is 5 years)
 Keep dry, out of direct sunlight or other UV (ultraviolet) sources and away from heat.
 Store in the box with part being covered with the black plastic, low density,
polyethylene bags (4mil/0.10mm minimum thickness) and re-seal the boxes.
 Periodically inspect for the presence of a soft chalky layer, easily rubbed off, which
would indicate deterioration
 Darkening or discoloration of elastomer parts over time is a natural occurrence and
does not by itself indicate any loss of properties.
Shaft Sleeve
Lantern Ring
Wear Plate
 Coat complete part with rust protector
Shaft
 Coat complete part with rust protector and wrap with 6mil/0.15mm VCI (Vapor
Corrosion Inhibitor ) plastic
O-Ring
Gasket  Check expiration date (shelf life is typically 5 years)
 Keep dry, out of direct sunlight and away from heat
Bearing
Bearing Isolator
Sealing Washer
 Check expiration date (shelf life is typically 1 year)
 Refer to Manufacturer’s Storage guidelines
 Keep in unopened box provided by the vendor

Keep dry, out of direct sunlight and lay flat
Motor
Sheave
Gear Reducer
Coupling
Bushing
 Refer to manufacturer’s storage guidelines