Krüger Technology KGVG4001, Инструкция по эксплуатации

Страница: 13 / 36

13
CONTROL PANEL
4a
7
6
1
4
2
5

1 General switch

2 Display

3 Hydrojet switch

4 Steam adjustment knob

4a Pressure gauge

5 Connector block for hose

6 Boiler On-Off switch

7 Water tank cap
PREPARATION and START TO USE
Open the cap (7) and fill the tank with tap water.
-Note:
If the water available should be
"very hard"(>20°F), It is recommended the use of 50%
demineralized water or distilled water,
(this to avoid
excessive limestone formations and to be sufficiently
conductive)
ATTENTION: Do not add detergents, anti-limestone
solutions or essential oils in the water tank boiler (7),
these can cause irreparable damage to the boiler and
circuits.
-Connect the plug to a socket on an electrical
interconnection conformed to the rules of the country,
equipped with a switch and an earth terminal efficient.
START TO USE:
Turn the main switch on (1). The pump will charge the
boiler before starting to heat.
The display (2) will turn on and indicate for a couple of
seconds the revision index of the PCB, the liter of water
consumed and will proceed with the temperature-
pressure status (HEAT) of the machine. Activate the
Boiler On-Off switch (6) to ON (illuminated key). Note: If
you want to use the machine only for draining or rinsing
the boiler, leave it in the OFF position. When the
machine is ready, it will display "GO". (normally the
machine takes about 6 minutes to reach the ready
state.)
Choose the most suitable accessory for the needed use
and connected it to lance of the handle (14), then insert
the hose connector to the block (5), push until you hear
a click.
13

13 Vacuum switch
When the machine is ready, to release steam through
the handle of the flexible, press the button (13). Now
use the brush or accessory in the surfaces to be
cleaned.
Attention : it is recommended to perform the first
release of steam after the heating on a container for
about a minute, this is to collect any condensate water
generated in the initially cold ducts.
Attention : if you are working on delicate
surfaces or things, keep the steam jet at an
adequate distance of at least 20-40cm.
STEAM RELEASE REGULATION
:
Through the regulation knob (4) placed frontally on
the machine, you can gradually adjust the release of
the steam.
END OF WATER : The acoustic and the visual
indicator of the display (2), indicates when there is no
more water inside the tank by showing "-H2O", this is
why the machine will stop the steam release.
WATER SUPPLY:
Proceed as described:
Open the cap (7) and refill the tank with water (check
the water level on the side label).
Close the cap.
You will hear the pump starting to work, please wait a
few seconds and then re-start your cleaning operation
with steam.