KROHNE VFC 200, Дополнительное руководство по инструкции

Страница: 37 / 40

PROFIBUS SETTINGS
4
37
VFC 200
www.krohne.com 06/2019 - 4005059401 - AD VFC200 PB-PA R01 en
4.4 Menu "D Service"
This menu is protected. You will need to use the service password to gain access.
4.5 Status messages and diagnostic information
Function Settings / descriptions
D4.0 Service Parameter D4.0 Service Parameter D4.0 Service Parameter D4.0 Service Parameter
D4.7.0 Identification No. Same as C5.8.6
D4.8.0 PB Cold Start Initiates a PROFIBUS cold start.
During a PROFIBUS cold start nearly all parameter values of the device will
be set to their default values except for the PROFIBUS address and number.
The PROFIBUS cold start will be carried out without disconnecting from a
PROFIBUS master system.
Select:
No (terminates this function) / Yes (PROFIBUS cold start will be carried out
at once)
Table 4-4: Description of menu "D Service"
NAMUR groups
(fixed level) NAMUR groups
(configurable
level) Group
no. Event
no. Event name Description
F_Electronics 30 17 FB Electronic Failure The fieldbus main board has an
electronic failure.
F_Electronics 30 16 FB Invalid Assembly/SN The fieldbus assembly is not
correct.
F_Electronics 30 15 FB (PA) Runtime Data
Failure
Runtime data failure occurred
in FB Main.
F_Electronics 30 14 FB (PA) Runtime
execution failure
Runtime execution failure
occurred in FB Main.
F_Configuration 29 24 FB Parameter update
failure
Failure occurred during
reading of parameters from
the Support MCU.
F_Configuration 29 23 FB NV data failure Data failure detected in NVRAM
of FB Main which cannot be
repaired.
F_Configuration 29 22 FB Configuration failure Configuration failure in FB
Main.
F_Configuration 29 21 FB Passivated Fieldbus application is
passivated.
F_Process 28 31 FB DeviceVariable
BadProcessPressure
The status of the fieldbus
device variable "Pressure" is
set to "BAD - process related".
F_Process 28 30 FB DeviceVariable
BadProcess
Temperature
The status of the fieldbus
device variable "Temperature"
is set to "BAD - process
related".
C_Configuration 25 29 FB Simulation Active Fieldbus Sim. Active
C_Configuration 25 28 FB DeviceVariable
BadFunctionCheck
Pressure
The status of the fieldbus
device variable "Pressure" is
set to "Bad - function check".
C_Configuration 25 27 FB DeviceVariable
BadFunctionCheck
Temperature
The status of the fieldbus
device variable "Temperature"
is set to "Bad - function check".
S_Electronics 22 30 FB Module out of spec. FB Main out of spec.