COMMISSIONING / OPERATION
3
29
VFC 200
www.krohne.com
06/2019 - 4005059401 - AD VFC200 PB-PA R01 en
How to read the mapping table above:
•
If e.g. the diagnosis event bit of "Event group" "C
C
C
C
–
Sensor
Sensor
Sensor
Sensor" (59) has been set both the
diagnosis event bit "Extension available
Extension available
Extension available
Extension available" (55) and the diagnosis event bit "Failure in
measurement" (29) will be set additionally.
3.3.3 Variable "Event groups"
As already mentioned in the standard instructions there are at least 3 "Event groups" available
with a variable classification ("F", "S", "M", "C" or "I"):
•
Config. - Process -> not supported by PROFIBUS
•
Config. - Initial -> not supported by PROFIBUS
•
Config. - High Flow -> changeable
•
Config. - Low Flow -> changeable
•
Config. - Power Failure -> changeable
•
Config. - Operation Info fixed to "Information"
If using the DTM or EDD
DTM or EDD
DTM or EDD
DTM or EDD you are able to choose one of the following settings:
DTM: Enter menu:
→
"Parameters
→
Input
→
Diagnostics":
EDD: Enter menu:
→
Online menu: "Device
→
Setup
→
Device
→
Diagnosis mapping and filter":
or
→
Offline menu: "<TAG>
→
Offline
→
Setup
→
Device
→
Diagnosis mapping and filter":
X
:
Corresponding DIAGNOSIS bit is set to 1 if status occured
Event Group 13: is fixed to "Information"
Event Group 8: will not be displayed within PROFIBUS Diagnosis / Diagnosis_Extension
Event Group 9: will not be displayed within PROFIBUS Diagnosis / Diagnosis_Extension
INFORMATION!
If "Event Group 13: Config.- Operation Info" is classified as "INFORMATION" then it cannot be set
within DIAGNOSIS_EXTENSION / DIAGNOSIS.
CAUTION!
It is recommended
recommended
recommended
recommended to use the default
default
default
default classification. If the default classification of a variable
"Event Group" should be changed please note:
