Krick ro1160, Руководство по сборке и эксплуатации, Страница: 29 / 72

- Solder the lubricating tube to the stern tube 3.2 in
the position shown.
- Drill a hole in the stern tube, working through the
lubricating tube. Blow out the stern tube carefully to
remove all drilling swarf.
- Mark the point „M“ on the stern tube 3.2 30 mm from
one end as shown, and slide it into the hull until the
marked point is visible.
- Screw the locknut 3.3 onto the propeller shaft 3.4 to
the end of the threaded section.
- File a flat at the other end of the shaft, asdescribed
for the motor output shaft.
- Slide the propeller shaft into the stern tube.
- Fit the grub screw 3.6 in the collet 3.5, and slide the
collet onto the front end of the propeller shaft.
- Lock the second coupling element 3.7 in place by
tightening the grub screw 3.8. Check that the grub
screw engages on the flat.
- Install the prepared motor assembly and connect the
propeller shaft 3.9. Check that the stern tube is an
easy fit in the hull without forcing the moulding out of
shape. File out the stern tube opening in the hull if
necessary.
- Remember to locate the stern tube at the marked
point.
- Tighten the grubscrew in the collet leaving 0,5 mm
axial play in the propeller shaft.