Krendl 5200-P, Руководство пользователя, Страница: 6 / 36

Rev. Date: 12/14/10 Page 3
MODEL #5200-P
General Safety
1. Read this manual carefully and become familiar with your machine. It is important to know it’s
applications, limitations, and any hazards involved prior to operating the machine.
2. This machine was designed and manufactured for blowing cellulose, fiberglass and
rockwool. Do not attempt to modify the unit or use it for any application it was not designed
for. If you have any questions about your intended use or the machine’s suitability, ask your
dealer/distributor or consult the factory. The manufacturers could not possibly anticipate every
circumstance that might involve a hazard. For that reason, warnings in the manual and
warning tags or decals affixed to the unit, are not all-inclusive. If you intend to handle, operate, or
service the unit by a procedure or a method not specifically recommended by the manufacturer,
first make sure that such a procedure or method will not render this equipment unsafe or pose
a threat to you and others.
3. Do not disable any of the safety features on the equipment. These features are for your
protection and safety.
4. Read and obey all safety and operating instructions in the manual and on the machine.
5. Equipment is to be operated and/or maintenanced by TRAINED & QUALIFIED personnel ONLY!!
6. BEFORE PERFORMING ANY MAINTENANCE ON THE MACHINE, YOU MUST FIRST:
#1 TURN THE DISCONNECT SWITCH TO THE “OFF” POSITION
#2 DISENGAGE PTO AND TURN THE TRUCK OFF
#3 TURN THE IGNITION TO THE “OFF” POSITION AND REMOVE KEY
7. Do not operate the machine without all guards and safety equipment installed in the proper
location and in working order. Always follow the proper shut down procedures outlined in Item 6
when guards are removed from the machine or when compartment or electrical control doors
need to be opened.
8. If a malfunction occurs while running the machine, turn it off immediately, follow the directions
under item 6 and correct the problem prior to restarting the machine.
9. Keep body and all clothing away from rotating equipment. Rotating shafts can be dangerous.
10. Always wear proper safety equipment when operating the machine. This includes steel toed
shoes, safety glasses and a respirator.
11. Under no circumstances should your hand, a stick or a broom be used to force material down
into the hopper. The machine is a self feeding design and requires no outside assistance.
12. Stand on the floor, not a platform while operating the machine. The operator may lose balance
and fall while loading bags of material.
All Model #5200 Machines are factory equipped with side, front, and main drive belt guards. The top
of the machine is not guarded since it poses no safety threat for normal insulation blowing operations
when mounted as shown in the installation guide. The machine is designed to be mounted in the van
body of the contractor’s truck and the rear of the machine against the wall of the van body.
Always turn the main power switch (located on the electrical box) to off and unplug the remote cord
from the receptacle for any type of machine maintenance or adjustments. An additional safety feature
is the ability to adjust the material slide gate from the outside of the machine. Rotate the adjustment
handle clockwise to open the slide to the desired setting, no entrance into the machine is required.
All safety features are incorporated into the machine to protect everyone from serious
injury. Operate your machine according to the outlined instructions in the manual with all
guards in place and securely latched. Operation with any guards removed can result in injury
to or loss of fingers, hands, arms, toes, feet, legs, hair, and even your eyes.