Krautzberger 1050-090-1127, Руководство по эксплуатации

Страница: 29 / 45

1. Interrupt the operation ( Ä Chapter 7.3 ‘Shutting down’ on page 25 ).
2. Switch off the system and secure it against being switched on again.
3. Connect cleaning product to material supply connection "M".
4. Switch on the compressed air supply.
5. Where applicable, switch on pump or pressure container for cleaning product.
6. Begin the spray process by switching on the control air (connection "St").
7. Spray until the cleaning product runs clear.
8. Interrupt the supply of cleaning product by switching off the pump or the pressure container.
9. Blow out cleaning product residue by briefly switching on the control air.
10. Switch off the compressed air supply and secure it against restart.
11. Clean the outside of the mini spray gun with a cloth dipped in cleaning product.
12. Remove material and air nozzle (
Ä
Chapter 8.4 ‘Changing the material nozzle and the air
nozzle’ on page 29 ) and clean with a soft brush. Do not use hard or sharp-edged objects.
We recommend our brush set. Please contact our Customer Care department for this pur-
pose.
13. Slightly grease sliding parts. We recommend Krautzberger special grease. Please contact
our Customer Care department for this purpose.
8.4 Changing the material nozzle and the air nozzle
Removing the nozzles
1. Clean the mini spray gun ( Ä Chapter 8.3 ‘Cleaning’ on page 28 ).
Fig. 7: Removing the nozzles
2. Loosen cap nut ( Fig. 7/3) and remove.
3. Remove/unscrew air nozzle ( Fig. 7/2).
4. Unscrew material nozzle ( Fig. 7/1).
Mini spray gun MA-1
ENGLISH
■ 200-0345 GB–29