2 If the inlet water pipe is 6mm, should ensure that the inlet water tube and connector have 30-40cm
of straight piping to avoid burst pipe accidents caused by bending in the pipe.
3 If the power cord wiring needs to be longer, then according to the wiring requirements use a Φ8mm
pinched tube to wrap around the connection, then on the outside wrap around insulating electrical
tape, do not place it on the floor, it should be suspended in the air or in another place away from the
ground.
4
When installing, if you need to make a hole in the wall, you should first make sure that there are no
electricity or water lines in the location you plan to drill.
5
！
The machine must be connected with the switch with reliable grounding line , otherwise
manufacturers are not responsible for safety accidents caused.
6
！
The switch power supply must switching power supply must put in ventilated and waterproof
place
，
and keep adequate distance with machine, in avoid of accidents caused by water input.
Testing Methods
After confirming that the water route connections are correct,
confirm that you have a power supply and/or water supply. Then
follow these steps to troubleshoot the machine:
Diagram 1
1
1. Open the tap water inlet valve as well as the water purifier inlet water ball valve, plug in the power
source (See Diagram 11), water will start to drain through the discharge outlet.
2. Wait for the water purifier to operate stably (about 5-10 seconds), check each connection to make sure
it is secure, see if there is any leakage from the membrane shells, filters, etc.
3. Close the pure water gooseneck faucet and storage tank ball valve, wait approximately 30 seconds,
check whether or not the water purifier waste water has stopped.
4. Open the gooseneck faucet, observe whether pure water is flowing through the faucet, if no pure water
is flowing, check whether the tap water pressure is too low or whether the high pressure switch cannot
be reset.
5. Wait until the machine is operating, close the inlet water ball valve, after a short time observe whether it
has stopped operating, if it has stopped operating, check whether the low-voltage switch can be reset.
6. Wait some time to make sure everything is correct, then the water purifier can be used safely.
7. Check the water quantity, which go to drain. It's should be according with the table 4.1
If the quantity of water is less than the information above it could
lead to quick failure of the membranes.
8. Check the TDS after some litters of water pass through the
gooseneck faucet. If the the membranes rejection is not very big,
please take out every membrane from the membrane shell and
insert it again with clockwise and anticlockwise rotations. Check it
again.
Note: The pure water TDS could be higher after coconut activated
post carbon filter till moment, when the unwanted active carbon go
out.
-16-
