Kratki PANTHER MERLOT, Инструкция по установке и эксплуатации

Страница: 67 / 108

67
USTERKA PROPONOWANE CZYNNOŚCI
The device will not start
(no audible confi mation
of the ignition procedure)
• Replace the batteries in the remote control and the receiver.
• If the receiver is powered by the power module assess its perfor-
mance.
• Reset the receiver and program a new transmission code.
• Make sure the receiver antenna is properly installed and not
damaged.
No voltage on the
controller coil (there are no
specific„clicks”)
• Make sure the switch cord in the gas control module is not
damaged.
• Short cyclical signals appearing when you try to switch on the stove
indicate the need to replace the batteries in the receiver.
• For one long beep:
- Make sure that the switch on the connecting cable from the gas
control module with the receiver is set to „I”. (Option)
- Check that the cable connecting the receiver to the gas control
module is not damaged.
- If the stepper motor is not working properly, replace the gas control
module.
- If the coil of the gas control unit is not working properly, replace
the module.
- If the micro-switch of the gas control module is not working proper-
ly, replace the module
No spark at the electrode
• Check the cable connection between the receiver and the electrode.
• Check that the electrode is not damaged.
• Check the operation of the sparker.
• Check that there is no system breakdown.
• If the ignition components are working properly and the fi ing
procedure does not start:
- Press the „RESET” button on the receiver.
- If it is possible, shorten the cable between the receiver and the
electrode.
- Add a grounding cable between the controller and the control
burner.
No control flam
• Make sure that the gas shut-off alve is open.
• Repeatedly make attempts to ignite the stove.
• Check that the pressure in the gas installation is appropriate.
• Check the connection between the breaker and the receiver.
After lighting the control
flam , spark still appears at
the electrode
• Check the connection between the breaker and the controller.
• In the case of damage to the electronic amplifie , replace the
receiver.
The control flam
extinguishes automatically
• Make sure the thermocouple sensor is operating and
• Properly connected to the gas control module.
• Make sure the flame ontrol is capable of heating the temp. sensor.
• Check that the gas valve of the gas control module is not damaged.
Weak control flam • Check the gas pressure in the control flam .