Kramer VP-438, Руководство пользователя

Страница: 15 / 26

Controlling the VP-438
13
13
Mode Function
HDCP ON OUTPUT Select FOLLOW INPUT or FOLLOW OUTPUT to define whether the HDCP will
follow the input or the output
When FOLLOW INPUT is selected, it changes its HDCP output setting (for the
HDMI output) according to the HDCP of the input. This option is recommended
when the HDMI output is connected to a splitter/switcher
When FOLLOW OUTPUT is selected, the scaler matches its HDCP output to the
HDCP setting of the HDMI acceptor to which it is connected
FACTORY RESET Resets to the default parameters (resolution is set to XGA or 720p
1
INFORMATION
)
Displays the source, the input resolution, the output resolution and the software
version
AUTO SYNC OFF Turn the auto sync ON/OFF. When ON, a short period after not detecting a valid
video signal on the selected input, the unit will disable the H and V syncs on the
analog outputs until a valid input is again detected or any keypad button is
pressed
EXIT Select to exit the menu
7.2.2 The FINETUNE Menu
Table 4 defines the FINETUNE menu:
Table 4: The FINETUNE Menu Features
Input Signal Parameter Function
CV,
COMPONENT
HUE Set the color hue
SATURATION Set the color saturation
SHARPNESS Set the sharpness of the picture
NOISE REDUCTION Select the noise reduction: OFF, HI, LOW and MID
(middle)
COLOR FILTER Set to ON to enable color filtering
2
VGA PHASE Set the clock phase
CLOCK Set the clock frequency
H-POSITION Set the horizontal position of the picture
V-POSITION Set the vertical position of the picture
AUTO TUNE
3
When set to ON, auto adjusts the image
4
COLOR FILTER
every time the
input is switched to VGA or when the input resolution
changes
Set to ON to enable color filtering
2
HDMI COLOR FILTER Set to ON to enable color filtering
2
1 If you cannot see the display after factory reset, use the front panel Res. button to set the correct resolution: press
continuously for 2 seconds to reset to XGA, or continuously for 5 seconds to reset to 720p
2 May improve the output image for certain graphic cards where color fringing is seen
3 Alternatively, you can auto adjust the image by pressing the ENTER button when not within the OSD menu
4 Centers the picture correctly on the screen