Kramer Electronics Ltd.
KDS-8-MNGR
– Telnet Control
67
set all voip uart route N1
set all voip uart route N1
Route the specified transmitter or receiver’s serial port Rx pin to all AVoIP devices’ serial
port Tx pins.
Available values for
N1
:
tx1~tx128 ............................. [Transmitter device ID]
rx1~rx128 ............................. [Receiver device ID]
set tx N1 ir 1 command [N2]
set tx N1 ir 1 command [N2]
Transmit the specified IR data via the IR output on the specified transmitter.
N1
= 1~128 ....................... [Transmitter device ID]
N2
= {IR ASCII hex data} .. [Pronto format IR data]
set rx N1 ir 1 command [N2]
set rx N1 ir 1 command [N2]
Transmit the specified IR data via the IR output on the specified receiver.
N1
= 1~128 ....................... [Receiver device ID]
N2
= {IR ASCII hex data} .. [Pronto format IR data]
set all tx ir command [N1]
set all tx ir command [N1]
Transmit the specified IR data via the IR outputs on all transmitters.
N1
= {IR ASCII hex data} .. [Pronto format IR data]
set all rx ir command [N1]
set all rx ir command [N1]
Transmit the specified IR data via the IR outputs on all receivers.
N1
= {IR ASCII hex data} .. [Pronto format IR data]
set voip N1 ir route N2
set voip N1 ir route N2
Route the specified transmitter or receiver’s IR input to the IR output on the specified
transmitter or receiver.
Available values for
N1
:
tx1~tx128 ............................. [Transmitter device ID (IR output)]
rx1~rx128 ............................. [Receiver device ID (IR output)]
Available values for
N2
:
tx1~tx128 ............................. [Transmitter device ID (IR input)]
rx1~rx128 ............................. [Receiver device ID (IR input)]
