![background image](http://html.mh-extra.com/html/kramer/kds-8-mngr/kds-8-mngr_user-manual_2002070067.webp)
Kramer Electronics Ltd.
KDS-8-MNGR
– Telnet Control
65
get uart 2 mode
get uart 2 mode
Show the current operational mode of the Control Output (5-pin) serial port.
set uart 2 command [N1]
set uart 2 command [N1]
Transmit the specified command data via the Control Output (5-pin)
serial port.
N1
= {Command data} ...... [ASCII text]
Note: To transmit hex data, each ASCII hex pair (octet) must be
preceded by “\x”. For
example a carriage return would be
“\x0D”.
set voip N1 audio out oN2 route N3 n4
set voip N1 audio out oN2 route N3 n4
Route the specified transmitter’s audio input to the specified receiver’s
audio output.
N1
= rx1~rx128 ................. [Receiver device ID]
Available values for
N2
:
1 ....................................... [HDMI audio output]
2 ....................................... [Analog audio output]
N3
= tx1~tx128 ................. [Transmitter device ID]
Available values for
N4
:
1 ....................................... [HDMI audio input]
2 ....................................... [Analog audio input]
Note: The values for N2 and N4 must match.
set all voip audio out oN1 route N2 N3
set all voip audio out oN1 route N2 N3
Route the specified transmitter’s audio input to all receivers’ audio
outputs.
Available values for
N1
:
1 ....................................... [HDMI audio output]
2 ....................................... [Analog audio output]
N2
= tx1~tx128 ................. [Transmitter device ID]
Available values for
N3
:
1 ....................................... [HDMI audio input]
2 ....................................... [Analog audio input]
Note: The values for N1 and N3 must match.