Kramer Electronics Ltd.
AFM-20DSP
– Defining Settings
56
Setting Parameters when DHCP is On
To set parameters when DHCP is set to On:
1. From the Navigation List, click
Settings
>
Communication
.
Note the Device Name in the General tab as you will need it after the page reloads.
2. Set DHCP to
ON
.
3. Click
Save
.
4. Type the device name in the address bar of your browser to reload the page.
You can read the new IP address from the Communication Settings page.
Parameters are set.
Performing Firmware Upgrade
To perform
AFM-20DSP
firmware upgrade, use the
Upgrade
tab in the
Settings
.
To perform firmware upgrade:
1. From the Navigation List, click
Settings
>
Upgrade
.
2. Click
Upgrade
and select the new firmware file.
The following message opens:
Figure 66: Upgrade Settings Tab
– Firmware Upgrade Message
3. Click
Yes
and wait for the upgrade to finish.
4. Wait for the device to restart.
Firmware upgrade is complete.