Kramer AFM-20DSP, Руководство пользователя

Страница: 17 / 90

Kramer Electronics Ltd.
AFM-20DSP
– Operating and Controlling AFM-20DSP
15
Operating and Controlling AFM-
20DSP
AFM-20DSP , AFM-20DSP-LE , AFM-20DSP-AEC can be monitored through the front panel
LEDs (see AFM-20DSP, AFM-20DSP-AEC Front Panels on page 5 ) and controlled via the:
•
Embedded webpages (see Using Embedded Webpages on page 18 ).
•
Protocol commands (see Protocol 3000 Commands on page 68 ).
Operating via Ethernet
You can connect to the AFM-20DSP via Ethernet using either of the following methods:
•
Directly to the PC using a crossover cable (see Connecting the Ethernet Port Directly to
a PC on page 15 ).
•
Via a network hub, switch, or router, using a straight-through cable (see Connecting the
Ethernet Port via a Network Hub or Switch on page 17 ).
To connect via a router and your IT system is based on IPv6, speak to your IT department for
specific installation instructions.
Connecting the Ethernet Port Directly to a PC
You can connect the AFM-20DSP Ethernet port directly to the Ethernet port on your PC using
a crossover cable with RJ-45 connectors.
This type of connection is recommended for identifying the AFM-20DSP
with the factory configured default IP address.
After the AFM-20DSP is connected to the Ethernet port, configure your PC as follows:
1. Click Start > Control Panel > Network and Sharing Center .
2. Click Change Adapter Settings .
3. Highlight the network adapter you want to use to connect to the device and click Change
settings of this connection .
The Local Area Connection Properties window for the selected network adapter opens.