Kramer Electronics Ltd.
AFM-20DSP
– Defining AFM-20DSP
5
Defining AFM-20DSP
This section defines
AFM-20DSP/LE/AEC
front panels.
AFM-20DSP, AFM-20DSP-AEC Front Panels
Figure 1: AFM-20DSP
and
AFM-20DSP-AEC Front Panel
AFM-20DSP-LE Front Panel
Figure 2: AFM-20DSP-AEC Front Panel
#
Feature
Function
STATUS LED
Indicates system status:
Almost 3 cycles of red/blue/off/green
LEDs flashing in sequence for about
30 seconds when system is starting
up, and the application has not been
launched yet.
Flashing green when application is
initializing.
Green when system is ready for
operation.
PORTS LEDs
(1 to 20)
Indicate port status:
Green when an input signal is
present, and the port is defined as
line in.
White when defined as line out.
Blue when defined as mic in.
Red when in clipping state.
Orange when in limiting state.
Off when there is no signal on the
input.
IN OUT DANTE™
LEDs (1 to 4)
Indicate Dante signal status:
Green when a signal is detected.
Red when clipping occurs.
Orange when in Limiting state.
Off when no signal is detected.
HDMI™
LEDs
EMBED
Turns green when an analog audio signal is associated with the HDMI OUT
signal. Otherwise remains OFF.
DE-EMBED Turns green when the HDMI IN audio signal is present. Otherwise remains
OFF.
IN OUT S/PDIF LEDs Indicate S/PDIF status:
Green when a signal is detected.
Off when no signal is detected.
If a signal is detected only on one channel, either left only or right only,
the status LED turns green.
1
2
3
4
5
