Kozy-World GLD2460R, Инструкция пользователя, Страница: 26 / 35

26
REMOTE CONTROL OPERATION NOTES:
The Thermo Feature on the transmitter operates the appliance whenever the ROOM
TEMPERATURE varies a certain number of degrees from the SET TEMPERATURE.
This variation is called the “swing” or temperature differential. The normal operating cycle of an
appliance may be -4 times per hour depending on how well the room or home is insulated from
the cold or drafts. The factory setting for the “swing number” is 2. This represents a temperature
variation of +/-2°F (1°C) between SET temperature and ROOM temperature, which determines
when the fireplace will be activated. The transmitter has ON and OFF manual functions that are
activated by pressing either button on the face of the transmitter. When a button on the transmitter
is pressed the word ON or OF will appear on the LCD screen to show while the signal is being
sent. Upon initial use, there may be a delay of three seconds before the remote receiver will
respond to the transmitter. This is part of the system’s design.
SETTING UP & USING YOUR REMOTE CONTROL SYSTEM
Notice: This guide is intended to provide supplemental information about setting up and
using the remote control that was included with your gas logs. It is not intended to replace
the information in the Owners Manual. Please refer to the Owners Manual for detailed
information about your appliance.
Install batteries. Batteries are required in both
the Remote (2AAA size) and Receiver (4AA
size). (See Fig. 39)
Helpful Hint: Be sure batteries are placed
correctly. Reversing the batteries can cause
damage to the receiver and remote. Replace
all batteries on a yearly basis or sooner.
Fig. 39
Fig. 40
Programming the Remote and Receiver
The remote and receiver must be “learned”
to one another. Place the slide switch on the
receiver in the Remote position.(See Fig. 40)
Programming the Remote and Receiver
Use a pen or small screwdriver to gently press
and release the recessed Learn button on the
face of the receiver (audible beep occurs).
(See Fig. 41)
Fig. 41
ADJ.
LEARN
ON
REMOTE
OFF
Fig. 42 Fig. 43
Programming the Remote and Receiver
Press the ON button on the remote (series of
audible beeps occur). Your appliance should
come on.(See Fig. 42)
Helpful Hint: If your appliance does not come
on check to make sure the control knob is in
the “ON” position.
Setting The Temperature
Press the SET button to change the temperature
setting. Release the SET button to choose the
desired setting. Your unit will cycle on and off to
maintain that selected setting.(See Fig. 43)