kozy heat Windim-WDM 56101, Инструкция по установке и эксплуатации

Страница: 18 / 41

Refer to the vent systems manufacturer's installation manual for complete installation instructions.
Installation must conform with the venting requirements and restrictions as outlined in this manual.
Simpson Dura-Vent DV-GS 4” x 6-5/8” direct vent system (horizontal and vertical terminations).
Ameri-Vent Direct Chimney System 4” x 6-5/8” (horizontal and vertical terminations).
Selkirk Metalbestos Chimney System 4” x 6-5/8” (horizontal and vertical terminations).
Metal Fab Chimney System: 4” x 6-5/8” (horizontal and vertical terminations).
ICC Chimney System: 4” x 6-5/8” (horizontal and vertical terminations).
This fireplace is designed to be used with rigid pipe only.
IMPORTANT: Consult the local and national installation codes to assure adequate combustion and ventilation air is
available.
HORIZONTAL VENT SYSTEM CLEARANCES
TOP BOTTOM SIDES
1-1/2 inches (38 mm) at wall pass thru 1 inch (25 mm) 1 inch (25 mm)
HORIZONTAL TERMINATIONS
MINIMUM: 6” (152 mm) hori termination cap.
MAXIMUM: 20 ft. (6.096 m) hori termination cap.
VENTING
PAGE 17
APPROVED VENTING
MAXIMUM VERTICAL RISE: 90 ˚ elbow + 28 ft. (8.534 m) ve termination cap.
VERTICAL TERMINATIONS
WARNING: A WALL PASS-THRU MUST BE USED ON ALL HORIZONTAL VENT RUNS.
HORIZONTAL & VERTICAL COMBINATION TERMINATIONS
PLEASE REFER TO VENTING CHART ON PAGE 20.
VERTICAL VENT SYSTEM CLEARANCES
TOP BOTTOM SIDES
1 inch (25 mm) 1 inch (25 mm) 1 inch (25 mm)
CAUTION: This gas appliance must not be connected to or joined with any other chimney flue serving another appliance.
For each additional 90° elbow used after the first elbow, 3 ft. (914 mm) must be subtracted from the maximum allowed venting. For each 45°
elbow used, 1-1/2 ft. (457 mm) must be subtracted from the maximum venting allowed.
NOTE: (1) 90
˚
elbow is included within the maximum vent runs.
(2) 45° degree elbows may be used in place of (1) 90° elbow.
ELBOWS