kozy heat Jackson XL, Инструкция по установке и эксплуатации

Страница: 17 / 37

E) POSITION THE FIREPLACE INSERT :
1. Slide the insert in the fireplace opening. The masonry panels, if used, secured to the air duct must be ‘outside’ the flange at the bottom of the insert .
NOTE: If the masonry panels are not „outside‟ the flange, it may cause a rattling noise when the fan is operating.
2. If necessary level the unit by screwing the(4) leveling bolts (A) into the nuts mounted in the bottom of the unit behind the lower grill. The leveling bolts are
included in the components packet. See Figure E-1 below.
3. Position the air duct to the fireplace by aligning the two holes in
the fireplace top to the studs on each side of the 4" exhaust duct.
4. Locate the baffle with the seasonal heat dump inside the fire
box and note the (2) access holes (A) on each side of the
heat dump.
Refer to Figure E-3.
Secure the air duct to the fireplace with (2) 1/4" nuts through
the access holes (A).
IMPORTANT: Make sure the gasket is properly seated.
5. Secure the lower end of the air duct to the firebox by placing a
1/4" nut onto each mounting stud (B) around the combustion
intake and tighten (4 total). Refer to Figure E-4.
IMPORTANT: Make sure the gasket is properly seated.
Figure E-3
Figure E-4
PAGE 13
Figure E-1
Figure E-2