kozy heat CSK-31, Инструкция по установке и эксплуатации

Страница: 17 / 34

Page 15
J) ATTACH THE SHROUD
Shroud assembly includes: (1) Shroud top (2) 10-24 x 1" RH Philips Mch Screw (#300388)
(1) Shroud left side (6) 8 x 3/8" Phillips PH-Type B Blk Zinc SMS (#300121)
(1) Shroud right side (4) 10-24 x 1/2" PH Phillips Truss head Screw BZ (300338-1)
(1) Upper Hood
(1) Lower grill
ASSEMBLE THE SHROUD - Figure J-1
1. Secure the right and left shroud pieces to the top piece
by aligning the (2) holes in the side pieces to the holes in
the top piece. Secure with 3/8" phillips head screws
provided (2 ea. side) (B).
2. Attach the upper hood to the shroud top piece by
aligning the holes on the top flange on the hood to the
corresponding mounting holes on lower inside flange of
the shroud top piece. Secure with (2) 3/8" phillips head
screws (A), provided.
ATTACH THE SHROUD - Figure J-2
1. Align the holes in the tabs located on the inside flange of
the shroud side pieces to the threaded mounting nuts
located on the inside side flanges of the insert.
NOTE: There are (2) for each side.
2. Secure the shroud by inserting (1) 1/2" phillips head
screw through the holes and into the threaded mounting
nuts. Do not tighten at this time.
3. Adjust shroud so that is sets against the fireplace face
finish material, then tighten the screws to secure in
position.
INSTALL THE LOWER GRILL - Figure J-2
1. Partially thread the 1" phillips head screws, provided,
into the mounting nuts on each side of the grill and
align to the corresponding mounting holes the inside
flange of the shroud side pieces.
2. Tighten the phillips head screws to secure the lower
grill in position.
NOTE: The grill may be adjusted slightly from side to
side if necessary.
Figure J-1
NOTE: Screws (A) & (B) are secured
from the bottom
Figure J-2 - Lower right side of insert and shroud shown.
Secure shroud with ½" phillips
head screws. (2) each side.
Secure lower grill with 1"
phillips head screw. (1
each side.)