kozy heat CHASKA 29 MV, Руководство по эксплуатации

Страница: 33 / 37

#CSK-29-MV R.6 January 2019 Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
TROUBLESHOOTING
33
Issue Cause Solution
Burner will not light
Lighting instructions not followed Turn gas control knob to ON position.
Turn the ON/OFF rocker switch to ON position.
Put wall switch, remote control, or thermostat in heat demand
position.
Plugged main burner orifice Remove blockage as necessary.
Switching device is defective Check remote, thermostat, or wall switch wires for proper connection.
Place jumper wires across terminals at switch. If the burner lights,
replace the defective switch, thermostat, or batteries in remote
control as necessary.
If switching device checks out as described above, place jumper wires
across switches on the gas valve. If the burner lights, the switching
wires are faulty or connections are bad. Replace as necessary.
Burner will not stay lit
Thermopile wires loose at valve
terminals
Tighten if necessary.
Thermopile wires ground out due
to pinched wires
Free pinched wires if necessary.
Improper refractory panel
placement (if installed)
Refractory panels must be tight against firebox walls. It may be
necessary to secure panels with high-temperature sealant, especially
around the intake duct.
Pilot and burner extinguish
while in operation
No propane in tank Check propane tank. Refill if necessary.
Incorrect glass frame assembly
installation
Refer toSection 9.1 Glass Assembly on page 24
Improper pitch on horizontal
venting
¼ in (6 mm) per 12 in (30 cm) is required on horizontal venting
Defective thermopile or
thermocouple
Check thermopile and thermocouple for proper millivolts
Inner vent pipe leaking exhaust
gases back into firebox
Check for leaks and repair if necessary.
Vent cap blockage Remove debris if necessary.
Glass sooting Improper log placement Refer to section 9.2 #CK29-500 Log Set Installation on page 25.
Improper venturi setting Venturi may need to be opened slightly to allow more air into the
gas mix. Refer to Section 12.2.1 Burner Venturi on page 31.
Incorrect vent cap installation Adjust if necessary.
Vent cap blockage Remove debris if necessary.
Flame burns blue and lifts off
burner
Improper venturi setting Venturi may need to be opened slightly to allow more air into the
gas mix. Refer to Section 12.2.1 Burner Venturi on page 31.
Incorrect vent cap installation Adjust if necessary.
Blockage or leakage of the vent
system
Check the vent pipe for leaks, and the vent cap for debris. Repair vent
pipe or remove debris from vent cap if necessary.