#ABY R.2 October 2020
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
FIREPLACE SETUP
31
6. Set retainer down on top of pipe. The 45˚ flange on the firebrick
retainer should now be behind the first pipe.
7.0 FIREPLACE SETUP
7.1 Firebrick Installation
The firebrick refractory panel is located on top of the pipes. DO NOT
DISCARD.
Measure the firebrick to follow along with these instructions.
The following firebrick are included with this fireplace:
(7) 4-1/2” x 9” (114mm x 229mm)
(6) 4-1/2” x 10-3/4” (114mm x 273mm)
(1) 4-1/2” x 4-1/2” (114mm x 114mm)
(10) 4-1/2” x 13-1/2” (114mm x 343mm)
(2) 2-1/2” x 13-1/2” (64mm x 343mm)
(1) Firebrick Retainer
1. Position (5) 4-1/2” x 13-1/2” (114mm x 343mm) fire bricks and
(1) 2-1/2” x 13-1/2” (64mm x 343mm) firebrick along back wall of
firebox.
2. Starting at back, position (3) 4-1/2” x 10-3/4” (114mm x 273mm)
firebricks under firebrick brackets along each side of firebox.
3. Place (7) 4-1/2” x 9” (114mm x 229mm) firebricks and (1) 4-1/2”
x 4-1/2” (114mm x 114mm) firebrick on firebox bottom (at the
center back).
4. Lay (5) 4-1/2” x 13-1/2” (114mm x 343mm) fire bricks and (1)
2-1/2” x 13-1/2” (64mm x 343mm) firebrick over the firebrick
refractory panel that rests on (4) stainless steel pipes at top of
firebox.
5. With the 45˚ flange down, slide firebrick retainer between the
top of the first pipe & firebrick. Push retainer back until it is
against the front of firebrick and under the refractory panel.
Figure 7.1, Step 1
Figure 7.2, Step 2
Figure 7.3, Step 3
Figure 7.4, Step 4
FIREBRICK REFRACTORY PANEL
Figure 7.5, Steps 5 & 6