34
FIREPLACE SETUP
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
#ABY R.2 October 2020
7.4.2 Door Catch Adjustment
NOTE: Washers are provided in the components part packet. You may
only need to place a washer at the top or bottom mounting bolt of the
mounting bracket, depending on where the seal needs adjustment.
You will be adjusting in the roller assembly to ‘catch’ the latch dog
assembly.
1. Open door.
2. Remove and save acorn nut on the fireplace faceplate securing
the roller assembly.
3. Place a washer (included in parts packet) onto top and/or
bottom mounting bolt on roller assembly.
4. Re-install acorn nuts.
5. Re-check door seal as instructed in Section 7.4.1 on page 33.
7.4.3 Door Adjustment
You will be adjusting the door up or down when attached to the
hinge assembly.
1. Open door.
2. Remove and save flange nut securing the door to the hinge
assembly.
3. Adjust the door up or down so it is level and seals properly.
4. Re-install flange nuts.
5. Re-check door seal as instructed in Section 7.4.1 on page 33.
Fireplace faceplate
Roller Assembly
Washer
Figure 7.9, Door Catch Adjustment
7.4.4 Latch Adjustment
You will be adjusting the hinge assembly for a better point of contact
to the roller assembly.
1. Open door.
2. Remove and save acorn nuts securing the hinge assembly to the
fireplace faceplate.
3. Adjust the hinge assembly left or right.
4. Close and latch door. Verify latch dog assembly aligns to roller
assembly.
5. Re-install acorn nuts.
6. Re-check door seal as instructed in Section 7.4.1 on page 33.
Figure 7.10, Door Adjustment
Figure 7.11, Latch Adjustment
