kozy heat 56150, Инструкция по установке и эксплуатации

Страница: 24 / 36

PAGE 23
1. Set thermostat to lowest setting, if installed.
2. Turn off all electrical power to appliance. (Fan).
3. Open lower grill to access gas valve & controls.
E. Push gas control knob in slightly and turn counter-
clockwise to „ON‟. The burner can now be turned
„ON‟ by depressing ON/OFF rocker switch located
beside valve, or wall switch, OR by setting thermostat
or remote control to desired setting.
F. Turn on all electric power to appliance (if applicable).
NOTE: When fireplace is initially lit, condensation
will appear on the glass; this is normal in all
gas fireplaces and will disappear after
several minutes.
LIGHTING AND SHUTDOWN (cont.)
A. Push gas control knob in slightly and turn
clockwise to “OFF”. Wait five (5) minutes to allow
any gas that may have accumulated inside firebox to
escape. If you then smell gas,
STOP! Follow safety
information on previous page and front cover of this
installation manual. If you don‟t smell gas, go to next
step.
B. Locate pilot - follow metal tube from gas control. The
pilot is located inside the combustion chamber.
C. Push gas control knob on gas valve in slightly and
turn counterclockwise to „PILOT‟. Push valve knob
in and hold while repeatedly pressing piezo igniter
button until pilot is lit while continuing to hold in gas
control knob.
D. Hold gas control knob in for one (1) minute after pilot
is lit. Release gas control knob. If pilot goes out,
repeat steps C-D. When pilot is lit, proceed to step E.
NOTE: Gas control knob cannot be turned from
“PILOT” to “OFF” unless knob is pushed
in slightly. Do not force .
PILOT TUBE
PILOT
B
C
D
1 MINUTE
E
LIGHTING
5 MINUTES
A
CAUTION: If knob does not pop up when released,
stop and immediately call your service
technician or the gas supplier.
If pilot
will not stay lit after several tries, turn
gas control knob to OFF and call your
service technician or gas supplier.