13
Position log #2, aligning notches in bottom of log to brackets in burner cover.
Position base logs #1, #3 & #4, aligning mounting holes in bottom of logs to corresponding mounting studs on burner cover.
Place logs #5, #6, & #7 over base logs, nesting them into corresponding notched out sections in base logs.
1
3
2
4
5
6
7
#BRK-500 LOG SET INSTALLATION
Use a steel or stiff bristle nylon brush to distribute Rock Wool Embers onto logs and burner.
Figure 13a
Figure 13b
CAUTION
Do not place logs directly over burner port holes. Improper log placement may affect flame appearance and cause excessive
soot to build up on logs and glass.
NOTE
Log numbers are located on bottom of each log. Refer to following instructions and illustrations for proper placement.
ATTENTION
If converting to LP (propane) gas, do so now before installing log set. Follow instructions included with conversion kit.
(Sold separately).
