11
10"
254mm
15"
381mm
17"
432mm
19"
483mm
10" (254mm)
12"(305mm)
14"(356mm)
3
4
"
19mm
MANTEL REQUIREMENTS
Rigid pipe:
1-1/2” (38mm) above elbow for entire width and depth (behind header) of fireplace.
#800-1 series flexible venting:
1” (25mm) above elbow for entir e width and depth (behind header) of fireplace.
NON-COMBUSTIBLE ZONE:
NON-COMBUSTIBLE MATERIAL ONLY
NON-COMBUSTIBLE ZONE:
NO MATERIALS ALLOWED ON TOP OF FIREPLACE
WITHIN SHADED AREA FOR ENTIRE WIDTH & DEPTH
OF FIREPLACE. THIS AIR SPACE MUST REMAIN OPEN.
HORIZONTAL VENT HEAT SHIELD
GLASS FRAME ASSEMBLY
1. Place glass frame assembly onto fireplace front.
2. Pull top handles out and down to secure glass frame assembly top.
3. Pull bottom handles out and up to secure glass frame assembly bottom.
REMOVE GLASS FRAME ASSEMBLY
1. Locate spring-loaded handles securing glass frame assembly at top & bottom of firebox.
2. Pull bottom handles out and down to release glass frame assembly bottom.
3. Pull top handles out and up to release glass frame assembly top.
4. Remove glass frame assembly from fireplace.
INSTALL GLASS FRAME ASSEMBLY
Pull latches out and down to release glass frame
assembly bottom.
Pull latches out and up to attach glass frame
assembly bottom.
Pull latches out and up to release glass frame
assembly top.
Pull latches out and down to attach glass frame
assembly top.
WARNING
TOP STAND-OFF BRACKETS MUST BE ASSEMBLED AND ATTACHED TO FIREPLACE. DO NOT REMOVE.
STAND-OFF BRACKETS ARE NOT LOAD BEARING.
CAUTION
TO PREVENT GLASS FRAME ASSEMBLY FROM FALLING FROM FIREPLACE AND BECOMING DAMAGED, FOLLOW THESE
INSTRUCTIONS EXACTLY WHEN REMOVING AND INSTALLING GLASS FRAME ASSEMBLY.
Figure 11b
Figure 11a
