Kozi MX2, Руководство пользователя

Страница: 20 / 40

Page 20
This button should only be used to fill the auger with fuel. Using this button during
normal operation will cause too much fuel to fall into the burn pot and may result in
damage to the heater or an unsafe situation.
4.6 “FAN” Button
During normal operation of your heater, the circulation fan (blows air into the room) will
run at a preset speed depending on the heat setting chosen (see “HEAT SELECT”
button). When the “FAN” button is pressed once, the circulation fan will operate on the
highest setting. Pressing the “FAN” button again will slow the speed of the circulation
fan to the next slowest speed. There are a total of 5 set speeds programmed on the
control board. Once the lowest speed is reached, pressing the “FAN” button brings the
circulation fan back up to the highest speed. Changing the HEAT SELECT setting will
change the circulation fan speed back to the preset level for that desired HEAT SELECT
setting.
4.7 “TRIM” Button
This button is used to compensate for fuel variations at the lowest heat level only. With
the heater at the lowest heat level (1) pressing this button once will increase the feed rate
to slightly above the normal low setting. At this “TRIM” setting, the (1) and (5) lights
will be on. Pressing the “TRIM” button again will cause the feed rate to decrease slightly
below the normal low setting. At this “TRIM” setting, the (1) and (4) lights will be on.
Pressing the “TRIM” button again will return the feed rate to the normal low setting. At
this “TRIM” setting, only the (1) light will be on.
4.8 Wall thermostat, wall switch or other switching device.
The
MX2
TM control is capable of using an external switch (such as a millivolt wall
thermostat) to turn the stove on and off. Any millivolt rated switching device can be used
with this control. The switch/thermostat must be wired to the terminals as shown in
Figure 18.
Figure 18. Wall thermostat terminals
Thermostat Wires
KOZI
Wall
Thermostat
MX
Control
Board
Connect Thermostat Wires Here