Koukaam NETIO-230B, Инструкция по эксплуатации

Страница: 19 / 22

•
< wd ip addr > - IP address of monitored device in seconds
•
< wd timeout > - maximum response time of monitored device
•
< wd POn delay > - Time (in seconds) for which the Watchdog feature will be inactive after
output restart. During this interval, the monitored device should recover to its normal opera-
tion after being restarted.
• < ping interval > - Interval (in seconds) in which the Ping requests to the monitored device will
be sent.
•
<
max retry
>
- Maximum allowed number of output restarts for the case that monitored device
does not respond to a Ping command. After the maximum number of retries is reached the
output will stay OFF.
•
< max retry poff: enable/disable > - enable/disable the function max retry
•
< send email: enable/disable > - enable/disable sending of e-mail messages unavailability of
monitored device, eventually, upon overrun of the max retry value
Example: The command port wd 2 enable 192.168.10.101 10 30 1 3 enable enable nable
enable will enable the Watchdog feature on output 2. Device on address 192.168.10.101 will be
monitored. Max Ping response time of monitored device will be 10 seconds. Ping commands will
be sent in 1 second intervals. If the monitored device won’t respond in 10 seconds, output 2 will
be turned OFF for 30 seconds. If the device will fail to respond to Ping commands after the third
restart the output will stay OFF. You will be notified by warning e-mail after each reset of the output.
system eth Shows current network interface setup in format: < dhcp/manual >< ip address >< mask >< gateway >
system eth < dhcp/manual > [ < ip address >< mask >< gateway > ] Setup of the network interface pa-
rameters – IP address, subnet mask and gate way parameters are needed to pass only if manual
mode is entered. To allow changed values to take effect you must restart the device by typing the
reboot command or turning it off and on again.
Example: The command system eth manual 192.168.10.150 255.255.255.0 192.168.10.1 will
set IP address 192.168.10.150, subnet mask 255.255.255.0 and default gateway 192.168.10.1.
email server
<
ip/domain server address
>
Sets IP address or domain name of the SMTP server.
system discover
<
enable/disable
> Enables / Disable visibility of the device for the network Discover
utility .
system discover hows if the option system discover is activated or deactivated.
system swdelay
<
delay
>
Sets delay between triggering two outputs. Value expressed in tenths of
seconds.
system swdelay Shows current delay between triggering two outputs.
system dns < ip > Sets IP address of the DNS server. To allow changed values to take effect, you must
restart the device by typing the reboot command or switching NETIO off and on again.
system dns
Shows current IP address of the DNS server.
18