5.2.1
Configuration of network parameters
Click
Configuration
link in the menu to change the system configuration.
Here, you can set up
IP Address, Subnet Mask, Default Gateway
and DNS Server according to your
network parameters. If you do not wish to setup the network parameters manually, you can
Enable
DHCP to obtain requested parameters automatically from the DHCP server in your network.
The parameter
Switch delay
(x0.1s) specifies delay between triggering two outputs. It avoids over-
loading of the device supply by turning all outputs ON at the same time.
The selections
KSHELL Port
and
WEB Port
allow change of default output for access via telnet,
eventually, device web interface.
Device name
allows you to insert the name of your device for easier identification in the future.
Firmware version
is just informative and shows the current firmware version.
After you make requested changes on this page and click
Apply
the device will change the param-
eters and restart automatically. After the restart you will have to login again.
Reset To Default
button
restores factory default settings.
Figure 9:
5.2.2
E-mail configuration
Click
Setup e-mail
and the form for adjusting e-mail settings can be seen on the right. Please input
sender (
From
), and recipient (
To
) of e-mail message. Also input the SMTP server address that will be
used to send out the e-mail. The last field (Warning MSG) is used to input the subject of the e-mail
message sent.
Click
Apply
to save. You can check if e-mail setup is correct by pressing the
Send test message
button.
11
Содержание NETIO-230B
Страница 1: ......
Страница 10: ...Figure 7 set up ports Figure 8 output configuration 9...
