Korg Electribe R ER-1, Руководство пользователя

Страница: 20 / 52

20
3. Basic operation (Quick Start)
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Pattern Set 1
Pattern Set 3
Hold down the Shift key
and press the Pattern Set key
to hold the Pattern Set function.
MIDI keyboard etc.
MIDI cable
Set the MIDI channel
Check the Part Note Number
4
5
1
2
3
MIDI IN
MIDI OUT
Playing with Pattern Set
What is Pattern Set?
Pattern Set is a function that lets you register a favorite pattern to each of the sixteen step keys, and use the
step keys to switch patterns. You can use this function to play a performance simply by selecting patterns
one after the other
When you hold down the Pattern Set key (the key will blink) and press
one of the sixteen step keys, the pattern registered for that key will be
selected. At this time you can use the Select keys to change the pattern
set group indicated by the red select LEDs (lower line) 1...4, to use 16 x 4
(total of 64) pattern sets.
If during playback you hold down the Pattern Set key and press another
step key, the pattern registered for that key will begin playing when the
currently-playing pattern finishes playing. (Refer to p.31 "Pattern Set.")
If you hold down the Shift key and press the Pattern Set key, the Pattern
Set function will be held. (The Pattern Set key will blink.)
To defeat this "hold" condition, press the Pattern Set key once again.
You can register new pattern sets. (Refer to p.31, "Registering a pattern
for Pattern Set.")
If you switch patterns during playback, the change will occur when
each pattern finishes playing. (Refer to p.22 "The timing at which
patterns will changed.")
Using the ER-1 as a tone generator module
Read this section when you wish to use the ER-1 with other connected MIDI equipment.
Use a MIDI cable to connect the MIDI OUT connector of your MIDI keyboard etc. to the
MIDI IN connector of the
ER-1 .
1. Press the MIDI mode key to enter MIDI mode.
2. Use the cursor [
▲
][
▼
] keys to make the parameter select
LEDs indicate MIDI ch .
3. Set the channel of the transmitting device to match the
channel of the ER-1 . (Refer to p.40 "MIDI channel set-
tings.")
4. Use the cursor [
▲
][
▼
] keys to make the parameter select
LEDs indicate Note No . (Refer to p.40 "Setting the MIDI
note number for each part.")
5. Press the desired part key, and the note number for that
part will appear in the display.
When you transmit the corresponding note from the trans-
mitting device, the sound of that part will be played.
For details on the ER-1's MIDI functionality, refer to
p.42 "About MIDI."
If you wish to save the settings of MIDI mode or Glo-
bal mode, you must perform the Write operation in ei-
ther of these modes. (Refer to p.39 "Saving the set-
tings you modify in Global mode ," or p.41 "Saving the
settings you modify in MIDI mode .")