JetNet 4706/4706f Industrial Managed PoE Switch
19
Below are the available commands for port interface configuration mode.
(VLAN) Interface Configuration:
Type
interface VLAN
VLAN-ID
in global configuration
mode. You can then enter the VLAN interface configuration mode. In this mode, you can
configure the settings for a specific VLAN.
The VLAN interface name for VLAN 1 is VLAN 1; VLAN 2 is VLAN 2.
You can type
exit
to leave or “
? “
for a list of available commands.
Available commands for the VLAN interface configuration mode appear below.
Switch(config)# interface vlan 1
JetNet 4706f(config-if)#
description Interface specific description
end End current mode and change to enable mode
exit Exit current mode and down to previous mode
ip Interface Internet Protocol config commands
list Print command list
no Negate a command or set its defaults
quit Exit current mode and down to previous mode
shutdown Shutdown the selected interface
Switch(config)# interface fa2
Switch(config-if)#
auto-negotiation Enables auto-negotiation state of a given port
description Interface specific description
duplex Specifies the duplex mode of operation for a port
end End current mode and change to enable mode
exit Exit current mode and down to previous mode
flowcontrol Sets the flow-control value for an interface
list Print command list
loopback Specifies the loopback mode of operation for a port
mac MAC interface commands
mdix Enables mdix state of a given port
no Negate a command or set its defaults
poe Configure power over ethernet
qos Quality of Service (QoS)
quit Exit current mode and down to previous mode
rate-limit Rate limit configuration
shutdown Shutdown the selected interface
spanning-tree the spanning-tree protocol
speed Specifies the speed of a Fast Ethernet port.
switchport Set switching mode characteristics
